Ftdi usb-rs485-xlr dmx512 fase belysning controller kabel til dmxking dmxcontrol freestyler dmx400

Tags: rgb-fan controller aurora, ftdi usb, dmx rj45, kæden stick, ftdi, arctis 3, esp32 ethernet, dell latitude e7470, usb-rs485 -, rs485.

ftdi usb rs485 dmx512 stage lighting equipment control cable diy for freestyler dmxking dmxcontrol dmx512 dmx400

With CD for FTDI driver and DMX freestyler software

diy rs485 dmx lighting control cable

how to make rs485 dmx control cable?welcome to sinforcon

freestyler3 Sunlite enttec kiss box elc eurolite dmx controller software free download

lighting equipment control software freestyler dmx400 dmx512 dmxcontrol download from sinforcon com website or contact us

Standard 10K ohm resistor for pull up and pull down resistors

USB to RS485 dmx cable for Stage Lighting Equipment control

USB RS485 TO XLR 3P female socket for dmx cable

XLR 3P male/female, XLR 3P female

USB RS485 converter

FT232+SP485

300 ~ 3Mbps baud rate

Up to 5km distance transfering

half duplex,non-isolated

ESD protection integrated

Support Android, Support Win 8, Win 7, win 10, Linix, Mac OS, Android

Internal 1024 byte EEPROM

support Vendor ID re-write,support Mprog3.5

Support FTDI VCP driver and D2XX driver

26AWG * 3 core, OD4.0mm, PVC jacket

0.15m ~ 1.8m workable

Application:

SGM USB uploader cable(XLR 5P)

DMXKing software DMXcontrol available from Sinforcon.com/download websites

Welcome to the FreeStyler website.

Freestyler is free lighting control software used by many

leading dj's, venues and lighting designers and supported

by a vast network of users worldwide.

If you are new to the site, check out our 'Gallery' page,

or just click on the right and download......

About FT232RL

The FT232R is the latest device to be added to FTDI?s range of USB UART interface Integrated Circuit Devices.The FT232R is a USB to serial UART interface with optional clock generator output, and the new FTDIChip-ID?security dongle feature.In addition, asynchronous and synchronous bit bang interface modes are available.USB to serial designs using the FT232R have been further simplified by fully integrating the external EEPROM, clock circuit and USB resistors onto the device.

The FT232R adds two new functions compared with its predecessors, effectively making it a "3-in-1" chip for some application areas.The internally generated clock (6MHz, 12MHz, 24MHz, and 48MHz) can be brought out of the device and used to drive a microcontroller or external logic.A unique number (the FTDIChip-ID?) is burnt into the device during manufacture and is readable over USB, thus forming the basis of a security dongle which can be used to protect customer application software from being copied.

Single chip USB to asynchronous serial data transfer interface.

Entire USB protocol handled on the chip - No USB-specific firmware programming required.

UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity.

Fully assisted hardware or X-On / X-Off software handshaking.

Dataoverførsel priser fra 300 baud til 3 Megabaud (RS422 / RS485 og på TTL-niveau) og 300 baud til 1 Megabaud (RS232).

Indbygget støtte til arrangementet tegn og line break tilstand.

Nye USB-FTDIChip-ID?funktion.

Nye konfigurerbare CBUS i/O-pins.

Auto sender buffer kontrol for RS485-applikationer.

Sende og modtage LED-drevet signaler.

Nye 48MHz, 24MHz,12MHz, og 6MHz clock output signal Muligheder for at køre ekstern MCU eller FPGA.

FIFO modtage og sende buffere for høj datakapacitet.

256 Byte modtage buffer og 128 Byte sende buffer anvender buffer til udjævning teknologi for at give mulighed for høj datakapacitet.

Justerbar modtage buffer timeout.

Synkron og asynkron bit bang-tilstand interface muligheder med RD# og WR# blitzlys.

Nye CBUS bit bang tilstand.

Integreret 1024 bit intern EEPROM til i/O-konfiguration og lagring-USB-VID, PID, serienummer og produkt beskrivelse strenge.

Enheden leveres forprogrammeret med unikke USB-serienummer.

Støtte til USB suspend / resume.

Støtte til bus powered, self drevet, og high-power bus powered USB-konfigurationer.

Integreret 3.3 V omformer til USB I/O .

Integreret converter på UART og CBUS for sammenknytning til 5V - 1.8 V Logik.

Sandt, 5V / 3.3 V / 2.8 V / 1.8 V CMOS-drev output-og TTL-indgang.

Høj i/O pin-output-drev.

Integreret USB-modstande.

Integreret power-on-reset kredsløb.

Fuldt integreret ur - ingen eksterne krystal oscillator, eller resonator, der kræves.

Fuldt integreret AVCC levering filtrering - Ingen særskilt AVCC pin-kode, og ingen eksterne R-C filter er påkrævet.

UART signal inversion mulighed.

USB-bulk transfer mode.

3,3 V til 5,25 V Enkelt Leveringen.

Lave drifts-og USB suspendere den nuværende.

Lav USB-forbrug af båndbredde.

UHCI / OHCI / EHCI-host controller-kompatibel.

USB 2.0 Fuld Hastighed, kompatibel.

-40°C til 85°C udvidet arbejdstemperatur.